What is an AN distribution box
A distribution boxes acts as the load center and main distributor of electrical power within a building.
Read More
How to unplug the stacked linear optical module
To remove the optical module, first unplug the fiber jumper, then flip open the pull-tab on the module and pull it out horizontally. Doing so may damage the module or deform the host's internal locking spring, affecting future module. However, with the right approach and careful handling, you can safely remove a transceiver stuck in a switch without causing damage to your network equipment. #opticalmodule #networkingProtect your SFP or SFP+ modules by inserting clean dust plugs into them after the fiber cables are removed, and be sure to clean the optic surfaces of the fiber cables before you plug them back into the optical bores of an SFP or SFP+ module. They enable high-speed connections between active equipment and allow system scalability without the need for full infrastructure replacement.
Read More
Optical Splitter Linear Disk
A beam splitter or beamsplitter is an that splits a beam of into a transmitted and a reflected beam. It is a crucial part of many optical experimental and measurement systems, such as, also finding widespread application in.
Read More
Photovoltaic panel voltage regulator module can be connected to load
A solar charge controller is an electronic device used in off-grid and hybrid off-grid applications to regulate current and voltage input from PV arrays to batteries and electrical loads (lights, fans, monitors, surveillance cameras, telecom and process control equipment, etc. To optimize system performance, these panels must be connected to a battery bank or other power storage system, as well as a voltage regulator. The voltage regulator will keep your solar system operating within a safe range, preventing damage from overcharging or undercharging. In this post I have explained how to construct a simple solar panel regulator controller circuit at home for charging small batteries such as 12V 7AH battery using small solar panel We all know pretty well about solar panels and their functions. The circuit of the solar PV system essentially comprises applications of the proposed charge regulator are of conversion, storage and load consumption devices also discussed.
Read More
Four Basic Principles of Relay Protection
The aim of this technical article is to cover the most important principles of four fundamental relay protections: overcurrent, directional overcurrent, distance and differential for transmission lines, power transformers and busbars. Contents:When phase-to-phase short circuit and ground short circuit fault occur, the phase-to-phase voltage or phase voltage at each point of the system decreases, and the closer to the short-circuit point, the lower the voltage. IEEE/IAS/I&CPSD Protection & Coordination WG Chair Jacobs Canada, Calgary, AB rasheek. com IEEE Southern Alberta Section PES/IAS Joint Chapter Technical Seminar - November 2016 Protective Relays - Technical Seminar Nov 2016 - Copyright: IEEE 2 Abstract: Protective relays and devices. Previous experience in designing low voltage and medium voltage switchgear, relay panels and custom control panels as an Electrical Engineer at ESSMetron, Denver CO. The selected protection principle affects the operating speed of the protection, which has a significant im-pact on the harm caused by short circuits.
Read More