VOLTAGE CONTROL AND REACTIVE POWER MANAGEMENT

Main power control distribution box

Main power control distribution box

A distribution boxes acts as the load center and main distributor of electrical power within a building. It takes electricity from the main source and safely sends it to different circuits in a home, office, or industrial setup.

Read More
High Voltage DC Bus Power Supply

High Voltage DC Bus Power Supply

These power supplies (Table 1) all provide high, reliable power with low noise and excellent regulation and can be controlled from the front panel or remotely through a number of interface options.

Read More
Cable Management and Bundling in Low Voltage Electrical Room

Cable Management and Bundling in Low Voltage Electrical Room

Cable trays or conduits for protecting and organizing cables, dependent on the size and requirements of your control box. Note that some organizations prohibit the use of zip ties; cloth ties are recommended in this instance. The control room is considered one of the most critical areas in any facility, impacting daily decision-making and overall. In the rapidly evolving landscape of modern electrical installations, effective Low Voltage Cable Management has emerged as a critical factor in enhancing system performance and reliability.

Read More
From the perspective of active and reactive power of relay protection

From the perspective of active and reactive power of relay protection

The most significant difference between the active and reactive power is that the active power is the actual power which is dissipated in the circuit. A protective relay is basically an electrical device that detects a fault in a power system and initiates the operation of the circuit breaker to isolate the defective section or component from the rest of the system. It highlights how energy is managed in inductive and capacitive elements within electrical.

Read More
Cables in power plant secondary distribution boxes

Cables in power plant secondary distribution boxes

This document applies to secondary cables in distribution substations used for protection and control purposes and LV power distribution. Primary distribution grid: This is the stage of electricity distribution where energy reaches substations to be transformed and distributed at medium voltage to the next phase of the grid for direct consumption by electro-intensive consumers such as industry. Electric power systems are designed to deliver electricity from generation sources to end-users safely, reliably, and efficiently. chgear, transformers, cables, overhead lines, surge arresters ding 1000 volts measured between the phase ing where the Equipment is protected against wind, rain, AC voltage Smoke Zero Halogen – cables with this t l is a synthetic ester based transformer i th a Quality Management Sys Power Sy pment.

Read More

Get In Touch

Connect With Us

📱

Spain Office (HQ)

+34 936 214 587

🇪🇺

EU Technical Center

+49 89 452 38 217

📍

Headquarters (Spain)

Calle de la Tecnología 47, 08840 Viladecans, Barcelona, Spain