THE DATA CENTERS HAVE ARRIVED AT THE EDGE OF THE ARCTIC

How to connect the wiring at the back of the distribution box

How to connect the wiring at the back of the distribution box

Connect the input and output wires to the corresponding terminals of the distribution box. It serves as a central hub for distributing electricity throughout a building, ensuring that power is delivered safely and efficiently to all the required locations. Materials: Inspect the cable distribution box and its accessories (such as fixed brackets, screws, terminal blocks, etc.

Read More
Immersion Liquid Cooling for Edge Data Centers in Japan

Immersion Liquid Cooling for Edge Data Centers in Japan

ITRI and KDDI, in cooperation with other IT enterprises, developed the Immersion Cooling Edge Data Center, using a non-conductive liquid coolant to enhance heat dissipation from servers and thus reduce carbon emissions up to 40%. Data center providers in Japan, KDDI and NTT Data, are exploring liquid immersion technology to significantly reduce the energy wasted on cooling server hardware. KDDI's recent field tests have achieved an impressive 94% reduction in electricity consumption for temperature control compared to. NTT is launching two liquid cooling deployments in Japan to further the technology. GIGABYTE Technology drew from its years of experience in the telco sector to provide the R282-Z93 and R182-Z91 Rack Servers for KDDI.

Read More
How far should the cable tray be from the bottom of the beam

How far should the cable tray be from the bottom of the beam

In general, vertical spacing for cable trays should be 30 cm (12 in), measured from the bottom of the upper tray to the top of the lower tray. This is a description of how to select, install, and support these metal or plastic frames, on which electrical wires are installed. Wire Mesh Cable Trays are mainly used for telecommunication and fiber optic cables. Any installed cable ladder, cable tray or channel support system can be considered structurally as a loaded beam (Figures 2); four basic beam configurations may be found in a typical installation: • Simply supported beam • Fixed beam • Continuous beam • Cantilever A single length of cable ladder.

Read More

Get In Touch

Connect With Us

📱

Spain Office (HQ)

+34 936 214 587

🇪🇺

EU Technical Center

+49 89 452 38 217

📍

Headquarters (Spain)

Calle de la Tecnología 47, 08840 Viladecans, Barcelona, Spain