GROUNDING IN A CONTROL PANEL

Grounding of control cabinet and distribution box

Grounding of control cabinet and distribution box

Grounding of the units: Attach a ground wire from one of the threaded studs (A) at the bottom of the housing, to the mounting plate (B). In today's industrial automation and control systems, electrical control panel cabinets play a critical role in ensuring the safe and reliable operation of equipment. EMC is the ability of electronic equipment to operate without problems within an electromagnetic environment. The primary purpose is establishing a zero-voltage reference point for circuit operation and protecting sensitive electronic components. The following guidelines should be observed when grounding a cabinet: An unpainted earth reference plane or rail must be installed on the floor of the cabinet for the conventional reference potential.

Read More
Several grounding points for communication tower feeder lines

Several grounding points for communication tower feeder lines

The fundamental objective of this document is to provide guidelines and practices for Ericsson site equipment grounding, with recommended methods that are essential to protect personnel, minimize component failure, and optimize performance by reducing electrical noise. #2 AWG minimum bare tinned solid copper ground wire may be used to bond air terminals to the tower. Because bonding and grounding systems within a building are intended to have one electrical potential, coordination between electrical and telecommunications bonding and grounding systems is essential during design and installation. It can enter via the feeder screens that are grounded at the top of the tower, via surge protective devices within or external to tower mounted electronics, via side flashing to exposed connection points and other electrical mechanisms.

Read More
How to convert a fiber optic panel to a network cable

How to convert a fiber optic panel to a network cable

To perform the conversion, you would connect the optical fiber cable to the optical fiber interface of the media converter. Fiber media converters allow you to connect two different types of network infrastructure: fiber-optic and copper (Ethernet). There are endless ways to configure a fiber-optic network, but here are a few simple ways to add fiber to your existing network. If the distance of your run is over 250 feet, we recommend using a fiber optic assembly.

Read More
How to prevent fiber optic panel breakage

How to prevent fiber optic panel breakage

To avoid fiber breakage, you should handle the fibers with care, use proper tools and techniques for splicing, terminating, and routing the fibers, and avoid exceeding the minimum bending radius and maximum tensile strength of the fiber. Key Risks and How to Fiber-optic cables are the backbone of modern connectivity—powering 5G networks, global internet backbones, and data center interconnections with near-light-speed data transmission. While these cables are engineered for durability (with some rated to last 25+ years), they are. Understanding the visual signs of fiber damage, knowing how to test them, and applying proper maintenance methods can dramatically reduce downtime and improve network reliability. However, in real-world installations, whether underground, aerial, or in harsh industrial environments, fiber cables can and do fail.

Read More

Get In Touch

Connect With Us

📱

Spain Office (HQ)

+34 936 214 587

🇪🇺

EU Technical Center

+49 89 452 38 217

📍

Headquarters (Spain)

Calle de la Tecnología 47, 08840 Viladecans, Barcelona, Spain