You have to issue the "no interface port-channel X" command in global config order to remove the port-channel interface. I inherited two Nexus 5548 switches with fabric extenders and I'm looking for the proper way to remove port channel group and the associated interfaces which are connected to a server we are repurposing and does need the four connections for etherchannel.
Read More
48 Core GYTC8S Fiber Optic Cable Armor Stranded Loose Tube Steel Wire Strength Waterproof Figure 8 Self Supporting Outdoor GYTC8S is a typical self supporting outdoor fiber optic cable, suitable for aerial applications; The cable have nice moisture resistance performance and crush. The optical fiber cable design provides easy and economical one-step installation and stable performance over a wide temperature range and is compatible with any telecommunication optical fiber cable. Optical fibres are housed in loose tubes that are made of high-modulus plastic and filled with water blocking yarns. The tubes (and fillers) are stranded around the central strength member to form a cable core.
Read More
Fiber loss, also called fiber optic attenuation or attenuation loss, refers to the loss of signal between input and output. Losses can be introduced by various means such as intrinsic material absorption, scattering, bending, connector loss and more.
Read More
To configure port aggregation, run aggregator-group id mode {lacp-negotiation |static }. The following list details the basic configuration parameters that should be consistent on all the ports: STP configurations, including STP enable or disable, STP priority, and STP cost. For a Layer 3 interface, if you want to configure a static IPv4 address, select IPv4 and refer to Configure Layer 3 Interfaces for configuring a static IPv4 address. LACP (Link Aggregation Control Protocol): LACP is an industry-standard protocol (802. 3ad) that dynamically manages link aggregation, provides automatic failover, and helps prevent misconfigurations by ensuring both ends of the link agree on the aggregation settings. Despite bundling multiple physical ports, the upper limit of transmission speed remains unchanged, as packets are still transmitted through a single.
Read More
Each network port has LEDs to show connection status and traffic activity, especially on switches and routers. Before you blame the switch or replace the cable, you need to look at the invisible data: the light levels. For network engineers working with fiber optics (SFP, SFP+, QSFP), understanding TX (Transmit) and RX (Receive) signal strength is critical. Switches have LEDs for indicating power status, port status,link status, error indication, troubleshooting and performance monitoring.
Read More+34 936 214 587
+49 89 452 38 217
Calle de la Tecnología 47, 08840 Viladecans, Barcelona, Spain