A diffractive beam splitter can generate either a 1-dimensional beam array (1xN) or a 2-dimensional beam matrix (MxN), depending on the diffractive pattern on the element. In its most common form, a cube, a beam splitter is made from two triangular glass which are glued together at their base using polyester,, or urethane-based adhesives.
Read More
Industrial electrical relay panels handle high voltages and large fault currents. Protective relays and devices have been developed over 100 years ago to provide "lastline"of defense for the electrical systems. They are intended to quickly identify a fault and isolate it so the balance of the system continue to run under normal conditions. That's why choosing the right protection infrastructure, including reliable Control & Relay Panels, is one of the most critical decisions any plant manager or electrical engineer will make. Traditional relay protection often falls ineffective in power-electronics dominated grids, increasing the risk of mis-operation or operation failure and compromising grid stability.
Read More
Soft Switching Techniques: Implement Zero Voltage Switching (ZVS) or Zero Current Switching (ZCS) to reduce switching losses. In Chapter 1, an overview and positioning of the three different semiconductor technologies (Si, SiC, GaN) is provided. Chapter 2 presents examples of topologies suitable for soft switching high-frequency operation, focusing on key applications in switch mode power conversion. Industrial high-frequency power supplies are evolving rapidly, driven by the need for higher efficiency, reliability, and intelligent energy management. , ANSYS or FloTHERM) to predict temperature distribution and optimize cooling structures, reducing trial-and-error costs.
Read More
Industry guidelines recommend: to maintain at least 20 cm (8 inches) between data and power cables when running in parallel; if cables must cross, do so at a 90-degree angle; use separate trays or conduits for high-voltage and communication cables; and for medium-to-high voltage. When a communications cable runs parallel and in close proximity to a power cable, these magnetic fields induce unwanted currents—a phenomenon known as inductive coupling—into the sensitive data conductors. This induced noise can corrupt the low-voltage data signal, leading to network slowdowns. Safety and signal integrity can be maintained by following the separation guidelines for the most common telecommunication pathway designs. From a containment perspective, what is the minimum separation distance between LV power (230V-400V) and unscreened UTP cable in the UK? Register to reply Already registered? Log in and reply There are really two considerations insulation failure /damage- what sort if cable is the UTP (would the. Prior to NEC 2026, many communications and separation rules were located in Article 800. These requirements are now distributed across Chapter 7—primarily Articles 725, 760, 770, 805, and 820.
Read More
In electric power distribution, a busbar (also bus bar) is a metallic strip or bar, typically housed inside switchgear, panel boards, and busway enclosures for local high current power distribution, transmission, or switching substations. A busbar power distribution system is a set of pre-engineered solid copper conductors that may be interlocked together to create various system configurations and lengths, providing a standardized solution for connecting and mounting electrical components inside the panel. Typically, a busbar is a flat strip or solid rectangular bar made of highly conductive copper or aluminum. Its size, shape, and whether it's bare or insulated depend entirely on the specific application, voltage, and current requirements.
Read More+34 936 214 587
+49 89 452 38 217
Calle de la Tecnología 47, 08840 Viladecans, Barcelona, Spain