Creating a 90-degree elbow in an electrical cable tray, often called a "fabricated" or "mitered" bend, involves cutting, bending, and fastening a straight section of tray. The most common method involves creating two 45-degree cuts to form a 90-degree angle. Here is the simple solution Create two type : 90 elblow and 45 elbow In the real world, to make a 45 elbow, we need two segments, to make a 90 elbow, we need three segments I've also tried to use some geometry forms in revit but no hope. The length of the bottom side (bottom diagonal) after bending the cable tray should be equal to the width of the cable. GRP-Elbow 90° for cable tray KK, small, with unperforated side rails, with moulded connector, glass fiber reinforced polyester, pressed, RAL 7032, pebble grey Refer to the product sheets for more information on product details and compatibility. Choose from the following: Horizontal elbows, Vertical elbows, Tees, Reducers, Cross pieces, Branches Class 1 Tray Fittings are designed for use with NEMA Classes 12B and 12C Cable Trays. The nVent CADDY Wire Basket Tray PreForm Elbow 90° is a precision-engineered solution designed to streamline cable tray installations when a directional change is needed.
Read More
